<font id="ln3r7"></font>

      <b id="ln3r7"><em id="ln3r7"></em></b>

            <font id="ln3r7"></font>

              <menuitem id="ln3r7"><video id="ln3r7"><meter id="ln3r7"></meter></video></menuitem>

              <font id="ln3r7"><video id="ln3r7"><meter id="ln3r7"></meter></video></font>

                          <font id="ln3r7"></font>

                          <menuitem id="ln3r7"></menuitem>

                          <menuitem id="ln3r7"><video id="ln3r7"><listing id="ln3r7"></listing></video></menuitem>




                                  業內資訊 當前位置:首頁 - 新聞中心 > 業內資訊


                                  來源:http://www.ahjinxia.com 時間:2022-04-06 

                                  The standard stone engraving machine and tombstone engraving machine are double cooled. On the one hand, because the stone material is hard, the water-cooled cutter head should be used when working. On the other hand, the water cools the spindle to prevent the spindle temperature from being too high and play a certain role in protecting the spindle. However, if the customer doesn't pay attention or doesn't follow the training steps, there will be no water and dry burning, which will cause serious damage to the machine itself.
                                  The dry burning of the spindle of stone carving machine is easy to lead to excessive heating of the spindle and burning out due to too high temperature. The spindle needs to be returned to the factory for repair. Then repair it and send it back from the factory. This cycle is about 1 week, which will seriously delay the normal processing period. If the customer is anxious to order, it will cause great losses. Therefore, when processing, customers must operate according to the training of factory technicians to ensure the normal use of the machine and prolong the application cycle of the machine.
                                  2、 If the main shaft of the stone carving machine is not cooled by water, it will always be in a state of continuous high temperature heating. It is easy to cause shaking or dislocation of the main shaft, fast and slow engraving and instability. On the one hand, the accuracy will be affected. On the other hand, the dislocation of the main shaft will cause the dislocation of the carved samples. The carved samples are naturally full of holes and are very not fine.
                                  The above is the detailed introduction of 3050 styrofoam engraving machine. I hope it will help you If you have any questions, please contact us We will provide you with professional service http://www.ahjinxia.com/